Outlast - Kleenstart - Concentrated granular pure oxygen cleaner for everything from furniture to fences

Outlast® KleenStart puts the cleaning power of pure oxygen into your hands. As it dissolves, the crystals of KleenStart release the oxygen bound up inside them - giving you nature’s own way of cleaning and brightening. Perfect for siding (both wood and vinyl), decks, roofs (wood as well as comp and tile), tents, log homes, outdoor furniture - anything and everything that requires a good deep- down cleaning and brightening. KleenStart rinses quickly and easily. No “slick” bleach residue requiring excessive rinsing!

Exterior Use Instructions

Wet down landscaping to dilute any over-spray mist that might come in contact with plantings. Wet down again at project completion to prevent spotting of foliage. Mix the quart size jar into 5- gallons of fresh tap water or 8-gallons of HOT water (or for smaller batches mix 1⁄4 to 1⁄3 cup granules per gallon of water). Stir until dissolved. Brush, roll, or spray onto surface until wet. Diluted material must be freshly mixed to be effective. You may also add the diluted liquid to the reservoir of a large capacity pump-up garden type sprayer and thoroughly wet the surface. Start at the bottom and work upwards. Allow the liquid to sit for approximately 10 minutes to loosen soil and debris. Re-wet if it dries. Further loosen surface debris with a garden hose or (best) pressure wash from the top down. Re-apply a second treatment to initially unresponsive, heavily discolored areas. Use all mixed product immediately while it's still releasing it's oxygen cleaning power for best results.

Interior Use Instructions

KleenStart has a mild “bleaching” action which will change wood color slightly as it cleans. Test the effect of the solution in a small area before starting so you will know what to expect. Divide surface areas into manageable sections with defined start and stopping points. This will ensure a uniform end result. Lightly scrub with a nylon bristle brush if needed. Rinse with clean terry cloth towels dipped several times in fresh clean water. Replace rinse water often.

*Note about water. All water is NOT THE SAME! KleenStart may not completely dissolve in water with certain mineral content and cooler water temperatures. For instance, product mixed in very cold water will normally have a bit of particulate residue remaining in the bottom of the bucket. If the residue is present, simply filter the liquid prior to pouring into a pump-up or other spray apparatus to prevent clogging. When possible, use hot water.

Diluted material must be freshly mixed to be effective. Keep unmixed granules in original container tightly sealed to maintain quality. A one-quart container cleans up to 1200 square feet of surface area.

Precautionary statements: Contains Sodium Percarbonate. Do not allow powdered material to contact eyes! Use of goggles while pouring or mixing the powdered material is highly recommended. If contact occurs, rinse eyes with large volumes of clean water. If irritation persists contact a physician. Incidental skin contact should pose no health threat, but as with all chemicals, the use of rubber or neoprene gloves is recommended. Please refer to the product SDS for further information.

• Wet surface and allow the cleaner to work for approximately 10 minutes. Keep surface moist. If needed, scrub surface with a stiff brush.

• Loosens stains caused by mildew and mold for easy rinse away with light pressure washer.

• Gently brightens wood surfaces.

• Mix smaller quantities: 1⁄4 to 1⁄3 cup concentrate per gallon of water - use less with HOT water.

• Readily rinses off! Great for interior cleaning!